Thread: Large hole in redgum

I still think I could cut it out with a small chainsaw and trim it up with a sharp chisel. Bring it up here and I will show you how.

Originally Posted by Twist

Thanks for the replies.
I'm going to try the jigsaw first, seems like the easiest option if it works. I needed an excuse to buy a better one anyway.
I'll be surprised if it can handle 10cm of redgum without the blade breaking but fingers crossed.

Cheers

Unless the blade is longer than the wood is thick dont even try.
Regards
John

Perhaps you could just roughly chisel it out, then use a disk style flap sander on a drill?

The disks are amazing. The 40 grit is like a chainsaw. 120 cleans up everything quickly.

I would suggest doing a series of holes and using a chisel to break the connection between the holes. It will be slow going so take you time and you will get through it.

You were right, good old fashion grunt work was the best way. Now I need to think of the best way to smooth it up.Will try an angle grinder with a sanding disc for the bits I can get it in, I'm thinking something to go on the end of the drill for the tighter ends.


hole.jpg

Looking good.


Sent from my iPad using Tapatalk

A big rasp?

Russ

Made some progress today, my friend the angle grinder cleaned it up the front surface pretty quick, orbital will be next.

The back come up great with some wire brushing.

The last photo is a mockup of what I'm aiming for, well it has changed slightly along the way as they always do.

front.jpgback.jpgRedGumSculptureMockup.jpg

I'll give you $100 for it... and pick up...

My first wood sculpture is complete, thanks for your advice.

IMG_7325-sm.jpg IMG_7326-sm.jpg

I like it. Nicely done.
Bruce


Sent from my iPad using Tapatalk

I like that a lot well done!

Agree the Arbortech is a good option . You will need to practice and build some confidence before attacking the valuable slab