Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: 2 panel door
-
13th March 2020, 04:33 PM #1New Member
- Join Date
- Nov 2013
- Location
- Marshall
- Posts
- 3
2 panel door
Can anybody give me some advice on the amount that can safely be removed from the top or bottom of a 2 panel internal door
-
13th March 2020 04:33 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
13th March 2020, 05:42 PM #2GOLD MEMBER
- Join Date
- Aug 2011
- Location
- bilpin
- Posts
- 3,559
Depends on the type of door. Is it solid timber, mortise and tenon or dowelled? Is it a pressed panel door?
-
14th March 2020, 12:14 PM #3GOLD MEMBER
- Join Date
- May 2015
- Location
- Brisbane
- Posts
- 1,147
Top and bottom rails on a hollow core door are usually around 30-35mm but i wouldn't cut more than 10mm each end. If you need to cut more than the rail width then cut right through the door and clean up the rail and glue and cramp it back in again.
-
14th March 2020, 02:10 PM #4New Member
- Join Date
- Nov 2013
- Location
- Marshall
- Posts
- 3
Thanks double.d I only need to cut off 10mm. Best I could tell it has a top rail of around of 35mm.
Thanks again.
-
14th March 2020, 02:14 PM #5New Member
- Join Date
- Nov 2013
- Location
- Marshall
- Posts
- 3
Thanks rustynail for your reply.
Similar Threads
-
4 panel door timber ID
By Timmymacca in forum TIMBERReplies: 8Last Post: 2nd September 2013, 05:25 PM -
Help for Gliderol Garage Door (panel door)
By apple0604 in forum NOTHING AT ALL TO DO WITH WOODWORKReplies: 13Last Post: 31st August 2012, 03:14 PM -
Raised Panel Door ?
By pjc in forum WOODWORK - GENERALReplies: 6Last Post: 30th November 2007, 08:35 AM -
Flush Panel Door
By Otwaymist in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 3Last Post: 29th November 2007, 05:39 PM -
Garage door noise - panel vs roller door choice ?
By Justin in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 20Last Post: 17th March 2007, 07:16 PM