Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: these chisels any good??
-
20th May 2004, 06:51 PM #1Novice
- Join Date
- Apr 2004
- Location
- sydney
- Posts
- 20
these chisels any good??
just got the below set of chisels from swadlings at roseberry sydney.....
Record 'blue chip' bevel edge chisels.
paid $59 for the set. from the reaction f the guy who did the price check, i would say he was close to making a mess in his pants.....he reckons they are about close to $30 a chisel.
was he pulling my leg just too sell the things?? did i get them for a decent price or is this how much their normally worth.
PS: did search on net an could not find much
-
20th May 2004 06:51 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
20th May 2004, 07:21 PM #2
Perception of value comes from within. If the benefits (functional and emotional) outweigh what you gave up to get them (money, time etc), then they are of value to you
But really, the retail price was about right - on the decent side.
(but be realistic with your expectations of performance from them).
-
20th May 2004, 08:27 PM #3Originally Posted by Bunyip
How Zen!Boring signature time again!
-
21st May 2004, 08:35 AM #4
The best chisel in my toolbox is a Bluechip I've had for about 25 yrs. It takes and holds an edge better than anything else I've got, and I have quite a few brands and nationalities represented there.
The 'worst' chisel in my toolbox is a Bluechip I've had for about 12 yrs - I use it for really rough stuff, straight off the grinder - it's not worth the trouble of trying to hone it, - too soft. In a way, it's a very useful thing to have, so I'll have to find another junky one when this one is used up, which won't be all that far away because of the way it gets used. (I guess that shouldn't be too difficult an exercise!)
Despite assuring us that blades are hardened to Rockwell X or Y, there seems to be a lot of variation from all manufacturers - why is this? I sharpen everything the same way, being very careful not to overheat anything on the grinder, and have always found this variablity. Is it just lack of control of the hardening/tempering process?
The Bluechip I abuse came from a bargain set like the one above - one turned out to be a 'keeper', two were so-so but I ended up trading them for a set of badly-abused 'antiques' (which turned out to be a very good deal!) and the last one is the 'paint-can opener' which I wouldn't have inflicted on anyone..........
You got them for about half the 'going' rate in most h'ware stores round here, and with luck they should all be useable, so go figure, as our friends over the Pacific say.
Cheers,IW