Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 20 of 20
-
2nd December 2014, 10:42 PM #16
Sorry Ian did not get pen to paper. Had a crazy arvo / evening. Will try to do a sketch first thing in the morning. Well let's say I'll try before 8:30
Dave the turning cowboy
turning wood into art
-
2nd December 2014 10:42 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
3rd December 2014, 07:40 AM #17
G'day Ian
Hope this explains my idea
You may need a sacrificial table for your disc sander to put / nail a pin into.
Your jig starts with the wood almost flat against the sanding disc. You rotate it to to just past 90º, flip the work and do the other side.
With a stop for length and a fence for width your pieces should all be identical.
Hope this helps. Either way love to see what you finally decide in the end
Dave the turning cowboy
turning wood into art
-
3rd December 2014, 09:22 AM #18
Dave,
I went with the Chris/Ian method of using a bull nose router bit to create a rounded end on some wide flat 19 mm stock, which I then ripped into 11mm strips.
Worked a treat, as would your suggestion, but since I had the necessary equipment I didn't see the point in building a jig.
However, my approach would only work if you had the correct radius router bit, whereas your suggestion would work for any required radius.
The first picture shows a bit of scrap pine I used as a trial. I used some scrap Tassie Oak for the job.
As I said, I got a bit obsessive over this but I did want a nice round and even finish, and that's what I have achieved.
The project was to build display stands for some small radio controlled yachts.
I have attached some pictures.
You may be interested to know that there is not a single nail or screw and no glue was used thus far.
I haven't sanded anything yet as it's just a prototype at this point. The entire thing is held together with just dry fit dominoes and a couple of 6mm dowels for the pivots.
Thanks everyone for your input
Ian
-
3rd December 2014, 09:27 AM #19
looks great, glad you got what you wanted.
Thanks for the pics
Dave the turning cowboy
turning wood into art
-
4th December 2014, 01:24 AM #20
As usual there's more than one way to skin a cat and a good result in the end, and I learnt something as well.
Pete
Similar Threads
-
Create from a Crate
By AlexS in forum WOODIES EVENTSReplies: 11Last Post: 27th February 2014, 04:47 PM -
How do i create a car wheel
By mcchaddy in forum DESIGN & DESIGNING / GOOGLE SKETCHUPReplies: 3Last Post: 23rd June 2009, 09:41 PM -
to burn or create
By scubabob in forum WOODWORK - GENERALReplies: 8Last Post: 6th August 2006, 12:28 PM