Thread: Filling End Grain

would love to see a picture!

How about a fairly rich mix of shellac? I haven't used it specifically as a filler, but it seems to soak into the grain quite well and sand pretty smooth. It's food safe (used on boiled lollies) and gives a good finish, either by itself or after sanding and coating with oil.

Good Morning Badger

I have not used shellac as Alex suggests, but I have used both epoxy and polyurethane in a similar manner - usually in a process leading to faux french polishing. My technique is as follows:

1. Do not use any commercially available filler or wood dust as filler in end grain as the filler is always obvious and looks 'orrible.
2. After fine sanding, vacuum clean and then wipe with solvent (turps or acetone) to remove all dust.
3. Pint on a coat of clear epoxy or estapol, wait ten minutes, then rub lightly with a clean, lint-free rag. This forces resin into the grain.
4. When dry, repeat step 3, until grain is totally filled. Wet surface will be uniformly shiny when this happens. Usually 2 or 3, but sometimes 6+ coats required.
5. Apply 2 or 3 more coats but do not rub off. Sand lightly with very fine 500 or 600 grit between coats.
6. Let cure for a week, then rub on 3 coats of danish oil.

Result is faux french polish - looks the goods, but is not vunerable to heat or spilt alcohol. Might be worth doing a practice board first.



Fair Winds

Graeme

Hi Badger, I haven't had to do this, but have read an article or two on what needs to be done

think of end grain as being a bundle of straws end grain. Until each straw is totally full of finish the grain is not filled.
Most available finishes are non toxic once the solvent has evaporated or the drying/setting reaction is complete.

Greame's technique with clear epoxy sounds a fast way of filling the straws

Thanks Guys.

That was just the advice I was looking for.

If it turns out OK I'll post a couple of pictures. If you ask really nicely, I'll even embarrass myself and include some of the pics I have taken while making the brute. (Anything happens to this one - I'll NEVER make another!!!)

Badger

Originally Posted by Badger

......(Anything happens to this one - I'll NEVER make another!!!)

.....

Now that's pretty hard on your self.


Does not matter if it's good or not we like to see photos of people work.