Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
-
20th May 2010, 02:17 PM #1New Member
- Join Date
- May 2010
- Location
- ACT
- Posts
- 3
Fixing Hardwood slats to metal Posts
Hi All,
I am a new member and have read with interest old posts on this topic. I am trying to fix hardwood slats to metal posts for a privacy screen. I have the good Tec screws and have pre-drilled through the timber. However, I find the drill cuck just spins and the screw won't turn once it hits the metal.
Maybe I need to buy a better cordless drill, or pre-drill the metal as well? Another option I guess would be to fix timber against the poles and screw the slats into them.
Any thoughts would be greatly apprecieated.
regards
-
20th May 2010 02:17 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
20th May 2010, 07:51 PM #2
Are you using a Hex driver bit?
Is the bit spinning in the chuck or on the screw?
From what you're saying, it sounds like the driver you're using is round, therefore the chuck won't grip properly, as there is a fair amount of torque needed to drive them through steelCheers
DJ
ADMIN
-
21st May 2010, 08:30 AM #3New Member
- Join Date
- May 2010
- Location
- ACT
- Posts
- 3
Thanks DJ's Timber,
I tried the phillips head bit and have now moved to the square raised head for more grip, but the drill is still spinning in the chuck!
I think I will pre-drill wider as the old poles are thicker than the new ones I added for support.
regards
-
21st May 2010, 10:17 PM #4
Hey Wayne is it too late to weld a piece of Flat bar or angle down the side of the post and drilling holes in it and screwing through that into the timber from behind?? the original post is probably too thick for self-drilling screws.
My two bobs worth
HazzaBIt's Hard to Kick Goals, When the Ba^$%##ds Keep moving the Goal Posts.
Check out my Website www.harrybutlerdesigns.com.au
-
24th May 2010, 08:39 AM #5New Member
- Join Date
- May 2010
- Location
- ACT
- Posts
- 3
Thanks HazzaB,
After a busy weekend I managed to pre-drill holes for the screws and purchased a you beaut Impact Driver - amazing what you can do with the right tools for the job. That has much more torque than a normal cordless drill.
Only 260 holes to go!
cheers
Similar Threads
-
How to fix merabu slats to square steel posts?
By thefireman in forum TIMBERReplies: 2Last Post: 30th November 2009, 08:31 PM -
Laminated Hardwood Posts
By GrahamC in forum TIMBERReplies: 13Last Post: 13th May 2009, 07:46 PM -
hardwood slats for privacy screens
By woodbutcheryeah in forum WOODTURNING - GENERALReplies: 1Last Post: 24th October 2008, 10:23 PM