Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: building doorframe in hallway
-
23rd November 2014, 08:22 PM #1New Member
- Join Date
- Nov 2014
- Location
- australia
- Posts
- 1
building doorframe in hallway
hi guys I want to build a door in a hallway I know I need to put up two studs I just need to know is it strong enough to fix the studs on the top, middle and bottom noggin and do I put the studs straight over the plaster.
-
23rd November 2014 08:22 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
24th November 2014, 08:26 AM #2SENIOR MEMBER
- Join Date
- May 2013
- Location
- Somerset Region, Qld, AU.
- Age
- 66
- Posts
- 602
Bolly,
Your question lacks enough information and clarity to enable people to provide you with any assistance. How about you provide some photos or sketches, along with a more detailed text explanation of your question. For example, the statement "do I put the studs straight over the plaster" doesn't make much sense. The more information and clarity you can provide, the more likely you are to receive a helpful and relevant answer.
RoyManufacturer of the Finest Quality Off-Cuts.
-
24th November 2014, 08:56 AM #3I now have 3 sheds
- Join Date
- Aug 2010
- Location
- Soldiers Point, NSW
- Age
- 60
- Posts
- 185
Hi Boily
That is exactly what I did with a small reno at home a couple of years ago. I put the new studs straight over the plasterboard, screwing into the existing top plate, bottom plate and nogg using 100mm 14g batten bugles. Make sure you drill a generous clearance hole for the bugle threads, especially if the existing frame is hardwood. With the thick bugles it may save you a wrenched wrist or broken screw or split timber. To access the top plate I had to cut a neat stud sized hole through the cornice and ceiling lining. Cut your studs to length after you have accessed the top plate location.
When I replastered the new wall I didn't square set the corner where it met the existing wall because I reckoned it would crack. I used a 15mm fillet of timber to fill the corner. The cornice join in the corner did crack pretty badly later on.
Hope this helps
Regards
Twosheds
-
24th November 2014, 10:45 AM #4
Two Sheds is on the money,Ive done it several times,make sure your layout is square and plumb to opposite walls,or your door may not sit flush to the jamb, if you have enough space use a trimmer stud next to the jamb stud , for nailing for your architrave, trench your header into the studs, theres lots more details but plan well ahead,Rossco
Similar Threads
-
Hallway mirror
By wireliner in forum WOODWORK PICSReplies: 3Last Post: 5th August 2014, 11:46 PM -
hallway door
By sinjin in forum WOODWORK PICSReplies: 2Last Post: 25th September 2010, 08:10 PM -
hallway table
By Trav in forum WOODWORK PICSReplies: 18Last Post: 18th August 2005, 10:08 AM