Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Ledge and Brace door question.
-
29th July 2016, 07:57 PM #1
Ledge and Brace door question.
I want to make some ledge and brace doors. I am using cypress pine from the Pilliga. Should I glue the ledges and braces to the upright slats? Or are the screws sufficient? Thanks in advance,
Michael
Robertson NSW.
-
29th July 2016 07:57 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
29th July 2016, 08:45 PM #2SENIOR MEMBER
- Join Date
- Aug 2013
- Location
- Montmorency Victoria
- Posts
- 554
I am no expert on these doors but I would think that screws would be best ... leaving room for expansion / contraction in the tongue and groove. I doubt that there would be too much vertical movement ...
Regards
Rob
-
30th July 2016, 10:13 AM #3
Grateful
Thanks Rob. Your idea seems to be the consensus so I will go ahead just with the screws.
Cheers,
Michael
-
30th July 2016, 02:40 PM #4SENIOR MEMBER
- Join Date
- Nov 2007
- Location
- Victoria
- Posts
- 734
From the australian carpenter book -doesnt mention screws or nails unfortunately but says to paint the joints not glue !
-
30th July 2016, 05:16 PM #5Woodworking mechanic
- Join Date
- Jan 2014
- Location
- Sydney Upper North Shore
- Posts
- 4,470
Made my shed door out of cypress tongue and groove floor boards.
Screwed only.
image.jpg
Similar Threads
-
Ledge and Brace doors.
By Michael Breen in forum HINTS & TIPSReplies: 6Last Post: 31st July 2016, 07:42 PM -
Chapman Brace question.
By Caliban in forum HAND TOOLS - UNPOWEREDReplies: 6Last Post: 16th October 2007, 11:28 PM