Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 8 of 8
Thread: Mounting a Dawn 225 vice
-
30th January 2013, 05:38 PM #1Awaiting Email Confirmation
- Join Date
- Feb 2008
- Location
- Peakhurst
- Age
- 67
- Posts
- 1,173
Mounting a Dawn 225 vice
Ok here's one for all and sundry......
How far below the top of the work bench should the top of the steel face be...25mm, 10mm greater or lesser
-
30th January 2013 05:38 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
30th January 2013, 05:43 PM #2
This is what I would do.
Fit (sacrificial) timber faces that are higher that the cast pieces so the top of the timber is level with the top of the work bench.
Depending on your bench allow 10-25mm.
I am sure you will get a few other opinions.
-
30th January 2013, 05:53 PM #3
I think mine is at 10mm and then a strip of timber over the metal. I have covered all the metal with a timber face.
Pat
Work is a necessary evil to be avoided. Mark Twain
-
30th January 2013, 06:19 PM #4GOLD MEMBER
- Join Date
- Aug 2011
- Location
- bilpin
- Posts
- 3,559
If a set of timber chops are fitted to the inside faces, the height of the vice below the edge of the bench is not critical, unless the vice is fitted with an adjustable dog, in which case the vice must be set within the range of the dog. With the dog in its lowest position being below the bench top surface.
-
30th January 2013, 07:47 PM #5
Some pics of my Dawn 9" set up as an End vice. I have a record 52 1/2 QR set up in on the left side in a similar fashion.
Dawn 9 01.jpgDawn 9 02 250mm.jpgDawn 9 03.jpgPat
Work is a necessary evil to be avoided. Mark Twain
-
30th January 2013, 11:06 PM #6Member
- Join Date
- Dec 2010
- Location
- Sydney
- Posts
- 98
Mines about 25mm below the top of the bench and I've had no problems. Obviously wooden jaws bring it back up to the same height as the work surface.
-
30th January 2013, 11:19 PM #7
-
31st January 2013, 12:40 AM #8Awaiting Email Confirmation
- Join Date
- Feb 2008
- Location
- Peakhurst
- Age
- 67
- Posts
- 1,173
Thanks lads..
I'll think about 10mm will do it.
Pat I love the end vice... just big,chunky and says don't mess with me.
I'll post some pics when all is done.
Similar Threads
-
Dawn No 7 Vice
By Twisted Tenon in forum HAND TOOLS - UNPOWEREDReplies: 9Last Post: 23rd January 2013, 07:01 PM