Picture(s) thanks: 0
Results 16 to 18 of 18
Thread: planing bit for a drill press
-
26th May 2020, 10:38 PM #16
Lovely work, Paul. Very different from what I had been imagining from the words ....
Personally, I would leave well alone, until you have well and truly tested the market. Its a very niche market, so when the right buyer comes along he (or she - it will probably be she) will hardly believe their luck that they have found something so specialised.
Once you remove the pen racks their absence will almost certainly always be evident in the colouring of the wood - I do not think that will enhance your work.
-
26th May 2020 10:38 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
26th May 2020, 11:43 PM #17GOLD MEMBER
- Join Date
- Sep 2011
- Location
- Valla Beach
- Posts
- 1,186
Hi Graeme and thanks. Actually I have already started on one, just the one. Going to see how it turns out when finished. The only places that might be evident of something there before is where the end of my pen holder thingy butts up to the side of the box/tray. Some fine light sanding then oil and wax should return that section to blend in. They are unique yes, I'll see how the first one goes. Thanks again Graeme,
Paul
-
27th May 2020, 10:00 PM #18GOLD MEMBER
- Join Date
- Apr 2019
- Location
- NSW
- Age
- 38
- Posts
- 1,134
i would buy a cheap slot drill for a mill around 8 or 10mm
then setup the depth stop on your drill press and just start peck drilling away at it just to eat away at the bulk
bottom out on the drill press depth stop and just slowly run it along to clear up the rest.
may have to use a chisel or something for the corners.
then just sand the best you can
- - - Updated - - -
i would buy a cheap slot drill for a mill around 8 or 10mm
then setup the depth stop on your drill press and just start peck drilling away at it just to eat away at the bulk
bottom out on the drill press depth stop and just slowly run it along to clear up the rest.
may have to use a chisel or something for the corners.
then just sand the best you can
Similar Threads
-
Bosch PBD 40 drill press - drill bit jammed
By eebee in forum GENERAL & SMALL MACHINERYReplies: 9Last Post: 10th May 2020, 10:05 AM -
Geared drill press vs belt driven press
By Albert in forum GENERAL & SMALL MACHINERYReplies: 20Last Post: 17th October 2016, 12:10 PM -
new drill press: quill stroke vs drill bit length ?
By bannock in forum GENERAL & SMALL MACHINERYReplies: 2Last Post: 21st June 2008, 09:09 AM -
Planing attachment for drill press?
By jmoore65 in forum GENERAL & SMALL MACHINERYReplies: 6Last Post: 15th February 2008, 06:01 PM