Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 17 of 17
-
31st December 2005, 12:43 PM #16
Also agree that hanging GPO's are the way to go. re placement of tools, I have put my Thicknesser and jointer side by side. These machines are often used in conjunction, so cuts down wood carting! Then try to place then near your roller doors so that long stock can poke out into the open when needed. make yourself some scale cutouts of the tools, incuding the room required for in and out feed of stock and try out a few layouts on parer (or CAD if available). Also plan your ducting for the DC at the same time. while my duct work is all overhead, if starting from scratch would seriously consider casting concrete plinths for machines and benches and buiding a false floor with enough clearance for all electrics and ducts. This can be a great arrangment both for tidyness and for access and change. you can even add plinths in the future!
Jacko
-
31st December 2005 12:43 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
31st December 2005, 02:20 PM #17
My fluros hang from a chain each end with a 2 meter 3 pin lead on each
Hang them over where ever and take them with you when you go, also good for bbq's etc
Woodworker 101 's tip on the arlec lead sounds good , run one or two high and drop leads from it or lights , plus take it when you go
RgdsAshore
The trouble with life is there's no background music.
Similar Threads
-
My shed accredited shed
By Waldo in forum WOODWORK - GENERALReplies: 52Last Post: 24th November 2006, 03:32 PM -
My Non-existent Shed Story
By RufflyRustic in forum WOODWORK - GENERALReplies: 14Last Post: 14th June 2005, 11:28 PM -
Shed, Garage or Workshop?
By bitingmidge in forum WOODWORK - GENERALReplies: 36Last Post: 2nd July 2004, 01:09 AM -
Shed Layout Software
By Wayne Davy in forum HINTS & TIPSReplies: 0Last Post: 15th May 2003, 12:13 PM