Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 19 of 19
-
1st June 2012, 11:04 PM #16
Maaaate!
15mm timber will be fine to screw into. But 65mm X 10#? Way too heavy for the size. I would not use a screw bigger than 8#, but no matter what screws you use, make sure you drill clearance holes with counter sunk for the screw heads,through the sides. Then to receive the screw into the end grain drill a hole equivalent to the screw minus the thread. By doing this you are proving a path for the screw and enough friction for the screw to bit into the end grain.
So, I am suggesting you using
* 50mm X 8# screws (either chip board or long treads- these look like a self tapping screw for sheet metal)
* With your timber sides 350mm wide I would put 5 screws in starting 25mm in from the ends and the rest spaced equally (only for looks)
*Do use PVA glue and a damp rag to remove the excess.
*With the bottom you can employ the same method and screw the bottom over the sides (that will be simple and with the screws strong too)
*What about the top? Is there one? Or will the box be open? Or will you want to hinge it?
I hope these suggestions are clear enough for you to successfully execute your first boxJust do it!
Kind regards Rod
-
1st June 2012 11:04 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
2nd June 2012, 07:33 AM #17
-
2nd June 2012, 08:22 AM #18
-
2nd June 2012, 08:34 AM #19
Forget the screws and go with a half lap joint and just use glue that will hold no problems at all.
Harold
Learn from yesterday, live for today, hope for tomorrow. The important thing is not to stop questioning.
Albert Einstein
Similar Threads
-
DON'T FREAK OUT - It's alright
By ubeaut in forum FORUMS INFO, HELP, DISCUSSION & FEEDBACKReplies: 10Last Post: 30th January 2011, 11:01 PM -
This look alright for DE off SCM you reakon ?
By JDarvall in forum WOODWORK - GENERALReplies: 13Last Post: 16th August 2008, 11:16 AM -
Alright Mik... goat island skiff?
By Wild Dingo in forum BOAT BUILDING / REPAIRINGReplies: 7Last Post: 29th January 2007, 12:24 PM -
problems screwing
By Rowan in forum WOODWORK - GENERALReplies: 17Last Post: 31st May 2004, 02:37 PM