Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Speed Cutting Dovetails
-
9th June 2021, 02:42 PM #1
Speed Cutting Dovetails
Tripped over this guy cutting dovetails ... rather quickly.
I beat the Dovetail Speed Run Record (2021) - YouTube
Reminds me of the time that I met Chris Vesper at a woodwork show in Hobart over twenty years ago.
Chris asserted that wood workers should warm up every morning before cutting wood. After all, opera stars sing scales, professional athletes do a warm up routine ....
"I cut dove tails." said Chris.
He had a lot of pre-prepared pine, about 60mm square and 5 mm thick - from salvaged fruit boxes? He used one piece of timber to mark the depth of cut on another, then cut the pins freehand (No marking out), transferred the lines and then cut the tails, all while talking to me and a couple of others.
I suspect his time was comparable to the above video, but his pace seemed quite leisurely, not rushed.
It blew my mind away at the time.
-
9th June 2021 02:42 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
9th June 2021, 07:03 PM #2GOLD MEMBER
- Join Date
- Jun 2005
- Location
- Helensburgh
- Posts
- 7,696
I recall reading many years ago that if you had a job coming up that needed hand cut DT's then every morning you walk into the workshop you should cut a couple to get your eye in.
CHRIS
-
9th June 2021, 10:23 PM #3
-
9th June 2021, 11:52 PM #4
-
10th June 2021, 07:02 PM #5
Methinks the dude should relax a little.
His caffeine levels seemed extreme
Similar Threads
-
Hand cutting dovetails
By AlexS in forum WOODWORK - GENERALReplies: 6Last Post: 28th January 2010, 08:43 PM -
Cutting speed guide.
By BlueMetal in forum ROUTING FORUMReplies: 10Last Post: 11th July 2009, 02:02 PM -
Cutting dovetails to cut dovetails
By derekcohen in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 14Last Post: 18th June 2008, 04:27 PM -
FWW article on cutting half-blind dovetails - the hardcore Dark-Side way
By Rocker in forum WOODWORK - GENERALReplies: 38Last Post: 28th June 2006, 10:13 AM -
Hand cutting dovetails
By Ben from Vic. in forum WOODWORK - GENERALReplies: 9Last Post: 1st November 2004, 10:57 PM