Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 6 of 6
Thread: stone house
-
6th September 2012, 03:34 PM #1New Member
- Join Date
- May 2011
- Location
- NSW
- Posts
- 4
stone house
Hi,
Am busy building a post & beam house with stone/masonry infill for walls.
I have erected the post & beam structure on the concrete slab & am about to start laying stone (slipform method) & concrete for the walls.
My question is -
should I tie the timber posts into the concrete/stone wall or should I be leaving a gap (later to be filled with a flexible filler) around the posts.
the posts have been treated & are dry.
Any feedback would be greatly appreciated.
Cheers
-
6th September 2012 03:34 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
6th September 2012, 03:55 PM #2New Member
- Join Date
- May 2011
- Location
- NSW
- Posts
- 4
initially I was planning on tieing the posts into the concrete wall by means of hammering nails half into the post, thus giving the concrete something to attatch to....
but recently had someone suggest to me that if the timber posts are tied into the concrete then there is the risk of the walls cracking as there could be movement from the post...
-
6th September 2012, 04:21 PM #3
I reckon you'd be better to ask on our sister forum Renovate Forums - Home, as they deal with this sort of stuff mate.
-
7th September 2012, 08:56 AM #4
If you see a brick house being built , you will see that the walls are tied to the Stud frame , with metal strips nailed to the stub and set in the mortar between the bricks.
This is done at several levels and on several studs , on each wall.
You must remember that an external Brick Wall , has no structural capacity ,and is not load bearing wall, the load being carried by the stud framing.
Jeff
vk4
-
7th September 2012, 11:09 AM #5
Definetly tie the stone to the post. There is nothing stopping the wall from falling either in or out. May be use the 1/2" foam expansion strip in the gap. the outer and inner pieces, may need two strips depending on the wall thickness, peal off so you can then fill with some form of mastic to stop draughts and insects.
peterI am learning, slowley.
-
7th September 2012, 06:30 PM #6GOLD MEMBER
- Join Date
- Aug 2011
- Location
- bilpin
- Posts
- 3,559
The stone infills are exactly that...infills. There is nothing supporting these sections of wall if they are not tied to the timberwork. If nailed ties are used, nails should be at right angle to expected force.
Similar Threads
-
tru stone
By eisbaer in forum WOODTURNING - PEN TURNINGReplies: 5Last Post: 11th July 2009, 07:15 PM -
1st Tru Stone Pen
By timberbits in forum WOODTURNING - PEN TURNINGReplies: 12Last Post: 20th December 2008, 02:36 PM -
what makes a water stone a water stone?
By contrebasse in forum HAND TOOLS - UNPOWEREDReplies: 13Last Post: 19th October 2006, 01:22 PM -
Oil stone or wet stone?
By woden in forum HAND TOOLS - POWEREDReplies: 18Last Post: 21st July 2006, 09:51 PM