Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: tapering legs on a jointer
-
25th February 2010, 02:51 PM #1
tapering legs on a jointer
refer also to the earlier thread....
https://www.woodworkforums.com/f11/ha...before-107592/
I'm sorry that it has taken so long but I am finally back on to the SECRET PROJECT and have attached pics of the first 'production' leg
DESIGN
each SECRET PROJECT has 4 legs and these are tapered on the inner faces only
MATERIAL
some of my Australian Red Cedar from Coffs Harbour, NSW (thanks Underfoot, Wheelinround and SIL Ben}
50 x 50 x 950
METHOD
fit a stop block onto the infeed table so that the beginning of the taper aligns with the contact point on the cutter
lower the infeed table to make a 3mm depth of cutter
this leg had 4 passes on each tapered face over the whole tapered length
set a stop block on the out feed table so that the length of the foot does not pass over the cutter
this leg had 2 passes on each tapered face with the infeed lowered a further 3 mm for each pass on each face. you could certainly do more passes on a lesser depth of cut to get the surface finish required
SAFETY
there was no unusual 'snatching' at the timber and the whole process was very tame, the only additional safety concern was moving the guard out of the way to lower the leg onto the cutter but I pushed the guard out of the way with the leg before lowering it onto the cutterhead
FINISH
I would normally cut all of the mortices etc before tapering so this leg has had a cursory sanding and a slapped on coat of shellac only
fletty
-
25th February 2010 02:51 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
25th February 2010, 03:05 PM #2
Good getting shed time isn't it Fletty
Secret project Hey girls I know all about it now who's going to be the highest bidder.
No way am I saying it Fletty............ other than good job well done
Similar Threads
-
A Simple Tapering Jig - heads up
By DPB in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 0Last Post: 7th November 2006, 09:32 AM -
LV Bevel Up Jointer Plane/Veritas Jointer Fence - Reviewed
By derekcohen in forum HAND TOOLS - UNPOWEREDReplies: 24Last Post: 14th January 2006, 06:09 AM -
Tapering(?) a long bit of dowel
By kentsusai in forum WOODTURNING - GENERALReplies: 12Last Post: 26th June 2004, 09:19 AM -
Tapering(?) a long piece of dowel
By kentsusai in forum WOODWORK - GENERALReplies: 1Last Post: 23rd June 2004, 12:38 PM