Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
-
25th April 2008, 11:38 AM #1Novice
- Join Date
- Apr 2008
- Location
- sydney
- Posts
- 23
Timber deck with no drainage problem
Hi there - I've just bought a house with a Tallowwood (we've been told) that was a) constructed with the straights very close to one another and b) has been painted so the end result is a deck with nowhere for the water to run - except for some occasional seepage points.
I've been told to drill some holes to let the water run out - but I was thinking it would look a lot nicer if I just used a circular saw to create gaps along the length of the deck between the boards.
Can anyone suggest which might be better?
Thank you
Peter
-
25th April 2008 11:38 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
25th April 2008, 02:14 PM #2
How big is it?
Put a spirit level on it and see whether it has a fall.
If it has, use a holesaw and put a couple of drainplugs (as in a shower) at strategic points.
If it does not have a fall do the same but along the length in a symmetric pattern. Be careful not to drill the holes where the bearers are.
It could end up looking like they were meant to be there if you paint them the same colour as the deck.
WolffieEvery day is better than yesterday
Cheers
SAISAY
-
25th April 2008, 05:42 PM #3Novice
- Join Date
- Apr 2008
- Location
- sydney
- Posts
- 23
THanks Wolfie
The deck is 12m x 3m - I'll check the fall next time I'm there.
P
-
25th April 2008, 11:45 PM #4Novice
- Join Date
- Apr 2008
- Location
- sydney
- Posts
- 23
Is the circular saw idea a bad one?
Hi - while I'm looking at the fall/ the option to put in drainage...do you have a POV on the idea of going at it with a circular saw to create gaps along the length of the wood...is it a very silly idea/ much harder than I think it might be?!
Thanks again
P
-
26th April 2008, 03:46 PM #5
I think you are going to have a helluva job keeping the saw straight at a 6 metre length with nowhere to put an edge guide. Let alone finding a 6 metre long straight guide.
I think you will come to grief halfway through.
WolffieEvery day is better than yesterday
Cheers
SAISAY
-
29th April 2008, 06:02 AM #6
You can make an edge guide by screwing 2x1's in position for each cut. Aside from that, I've never built a deck so I don't know if cutting is a good idea...although it wouldn't be my favourite option. Gut instinct tells me it just wouldn't look right. I don't know the age or condition..or design...of the deck, but is there any possibility of taking up a few boards and moving the others to create gaps? Or even better....make a few new boards with a trellis or hole pattern in them using a router. Put these in instead of some of the old ones, and paint to match.....just m2c.
Looking for an inexpensive accurate and detailed job estimation solution? www.dsm-systems.com
-
29th April 2008, 07:34 PM #7Novice
- Join Date
- Apr 2008
- Location
- sydney
- Posts
- 23
Thanks Wolffie and thkoutside...
I'll go for the draining option...if folks like you wouldn't attack it with a circular saw, I suspect I'd be mad to!
All the best.
P