Thread: torque workcentre accuracy?

Hello All;

I'm looking at upgrading some of my workshop and am considering a torque workcentre if only for the versitility per sqr meter factor.

I'm curious though about the accuracy and the ammount of play in the sliding mechanism, can you put a full sheet of ply down on it and rip it into three peice, without moving the board, and end up with parrallel sides?

My other question would be does the arm flex at all over the lenght of the cross cut i.e. can you do a long trench and get a consistent depth of cut?

Pardon if this isn't the right sub-forum for this question )

Thanks

Joel