Thread: Sharpening Chisels with Oil Stones

Oh no. Another sharpening thread. :eek: :eek:

Run away, run away

Have a look in the archives. Be prepared to spend plenty of time reading all the posts on this subject.

Scary sharp is probably the easiest method to master. Do a search on that as well.

Good luck.

mmm scary sharp. Doh!

J!

nothing wrong with oilstones.
chippies & cabinet makers have used them for many years!!!

Don't let them scare you. By all means do a search, oodles of info on sharpening. Waterstones seem to be the flavour of the month, so much so, I am really tempted to try them.

However, oilstones have been around for donkeys, so by all means use them.

Yes they will need flattening, they will probably be harder than waterstones, so a little more patience will be required.

Depending on your chisels, that shave the scrotum of a sleeping rat without waking him, may be beyond your stones, and possibly your knowledge at this time.

DON'T let this frustrate you, getting a really sharp edge is within your capability with a little practice. There is more info on the net on sharpening to sink a boat, let google be your friend.

A book by Lenard Lee, title escapes me, comes highly recommended.

Hang in there, practice, pereseverence, and oilstones will produce as good an edge as your tools will allow.

Ron Hock's Sharpening Notes are a good, comprehensive guide, regardless of sharpening medium.

http://www.hocktools.com/sharpen.htm

Enjoy.
Rus.

Redback,



I've used oil stones for chisels and plane blades for years, like you no idea of the grades but course, smooth and really smooth does it for me. The scary sharp method will certainly give you a sharper result if you stones are not that fine. However after much hesitation I have finally ordered some waterstones which should arrive soon and am keen to see if I really can shave that rats scrotum without waking him. So far smooth forearms are as far as I've gone. It's all just practice, you should be able to get a fine edge on those sheffield chisels, its how they hold the edge which probably tests the quality.



John

I have finally ordered some waterstones which should arrive soon and am keen to see if I really can shave that rats scrotum without waking him.

John

Oilstones have earned a good reputation. There is nothing wrong with using them. Personally, I have very little experience here. But what I have read makes two points: firstly, waterstones will sharpen to a higher grit and leave a keener edge; secondly, waterstones cut much faster than oilstones.

The only advantage of oilstones over waterstones is that they are less inclined to dish. On the other hand, once they do, they are harder to flatten.

Regards from Perth

Derek

Tauntons & Lee Valley have this highly recommended book:

http://www.thebestthings.com/books/g...sharpening.htm

Me, I just use carborundum for my chisels, some kero and a lot of practice .

Cheers