I bought a bench grinder, CBN wheel, Tormek BGM100 and SE-77 over a year ago and have only just set it up.

BGM-100 Bench Grinding Mounting Set | Tormek Australia
Jig for sharpening chisels and plane irons SE-77 | Tormek Australia

The instructions for the tormek arent that great.

I got the bar of the BGM as parallel as I could with wheel. When I grind the edge of chisels/plane blades it isnt 'perfect'.

To correct I was mostly using the little wheel on the threaded side of the bar - is that what it is used for? The issue with that is that you have to do it every time you need to shift the bar, which is pretty much every time you put a new blade/chisel into the tool holder as the protrusion wont always be the same.

The SE-77 also as 2 little knobs to adjust squareness - but I found that it didnt seem consistent?

Does anyone else have this problem?