![Thanks](https://www.woodworkforums.com/dbtech/thanks/images/thanks.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 4 of 4
Thread: Tormek T4 drive wheel melted
-
18th February 2018, 04:20 PM #1
Novice
- Join Date
- Jul 2011
- Location
- Sydney
- Posts
- 14
Tormek T4 drive wheel melted
I was grinding a new bevel on an old chisel that I had been given; someone had put a large back bevel on it in the distant past and I was removing it. The chisel was about an inch wide and I was pushing reasonably firmly when all of a sudden I could smell melted plastic and the middle of the drive wheel where it attaches to the shaft was fried (see picture). Has anyone managed to do this before with a T4?
Cheers Jarrod
P2182532.jpg
-
18th February 2018 04:20 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
18th February 2018, 04:52 PM #2
I have replaced two drive wheels on a 2006, when they cracked. The current one is reinforced (by myself) with carbon fibre and resin.
Regards from Perth
DerekVisit www.inthewoodshop.com for tutorials on constructing handtools, handtool reviews, and my trials and tribulations with furniture builds.
-
18th February 2018, 06:24 PM #3
Novice
- Join Date
- Jul 2011
- Location
- Sydney
- Posts
- 14
Thanks Derek,
It is good to see that others have also experienced problems with the drive wheel. I might have to get a few new ones and be a bit more gentle with them in future.
Cheers Jarrod
-
20th February 2018, 09:00 AM #4
GOLD MEMBER
- Join Date
- Apr 2011
- Location
- McBride BC Canada
- Posts
- 3,543
The large back bevel suggests to me that the chisel had been converted into a wood carver's "stop" chisel.
It's used to prevent long run-out splits when carving up to a vertical edge.
They get utilized for rough outline but little more.
I have a 1/8 Pfeil and made a 1/12 from a Narex 1/2" skew.
Jointed that on a high speed wheel than revised a 10 degree bevel on each side.
The bushing on the Tormek wheel must really be dumbed down for the design.
Similar Threads
-
Tormek honing wheel LA-220 actually is 215mm
By KnifeGrinders in forum SHARPENINGReplies: 2Last Post: 17th September 2017, 12:23 PM -
Tormek with Spark Grinder Wheel?
By BottleBolt in forum SHARPENINGReplies: 7Last Post: 27th February 2011, 02:08 PM -
Talon thicknesser-drive belt melted ! Need replacement.
By damianq in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 13Last Post: 20th August 2010, 12:57 PM -
Tormek with wobbly wheel
By Ralphie in forum SHARPENINGReplies: 2Last Post: 23rd May 2010, 08:59 PM -
Grind wheel truing with a Tormek BGM
By rsser in forum SHARPENINGReplies: 1Last Post: 11th November 2009, 04:21 AM