Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 18 of 18
-
8th November 2010, 04:47 PM #16Hewer of wood
- Join Date
- Jan 2002
- Location
- Melbourne, Aus.
- Age
- 71
- Posts
- 12,746
Sounds like you've given it a thorough workout.
With jigs like this I've found that very minor variations in clamping are magnified at the pointy end.
Stanley blades are fairly thin too so how you pressure the tip may well give you differing results, and indeed some folk exploit this to round off the corners ever so slightly.
Hock blades are nice; but the backs are not lapped at the factory and IME this should be done. This is a whole new realm of principle meeting frustration! ;-}Cheers, Ern
-
8th November 2010 04:47 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
9th November 2010, 05:43 PM #17
I think that you should not use crap blades that you have to hammer flat? Most people seem to consider the MK2 the bees knees i terms of results there have been rave report on it for over 3 years here and else where. I would try it on a good blade first and then report back.
"All that is necessary for evil to succeed is for good men to do nothing"
(Edmund Burke 1729-1797)
-
10th November 2010, 01:29 PM #18jenkinsr Guest
Similar Threads
-
Veritas Bevel Setter - Metric
By dynoforce in forum HAND TOOLS - UNPOWEREDReplies: 0Last Post: 16th May 2009, 08:26 PM -
veritas sliding bevel problem
By mic-d in forum HAND TOOLS - UNPOWEREDReplies: 9Last Post: 23rd May 2008, 12:50 PM -
Check your Veritas MkII Honing Guides
By Groggy in forum HAND TOOLS - POWEREDReplies: 17Last Post: 17th July 2006, 04:46 PM -
Problem - Micro Bevel setting on Veritas MkII Honing Guide
By silentC in forum WOODWORK - GENERALReplies: 32Last Post: 20th May 2006, 12:52 PM