Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 17 of 17
Thread: Bench grinder extension spindle
-
21st November 2013, 08:12 PM #16
Something that won't dry hard and tough. Think they used to use a form of the old stamp lickity stick gum. If it peeled of basically intact, you might be able to lick and stick it back on. If it sheered off unevenly, try coating it with some of the glue stick gum from a stationary store (or the children's school supplies) both sides, but you need to get it as close to the original position as possible so it mounts with the most even thickness, leaving it uneven by putting thickest replacement to thickest original will increase runout at the flange.
If the card is big enough and even in thickness, you could slide it on between the wheel and flange without glue and just sandwich it in place.
Remember it is basically just a self modifiable packer to even out the clamping pressure from the flanges.I used to be an engineer, I'm not an engineer any more, but on the really good days I can remember when I was.
-
21st November 2013 08:12 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
21st November 2013, 09:21 PM #17
Thanks Mal sounds easy enough.
Similar Threads
-
Hand Grinder / Manual Bench Grinder — General comments
By US-Oz in forum HAND TOOLS - UNPOWEREDReplies: 24Last Post: 6th June 2013, 07:59 AM -
Bench grinder tapered spindle attachment
By Tiger in forum HAND TOOLS - POWEREDReplies: 8Last Post: 16th May 2013, 10:00 PM -
Extension spindle for bench grinders
By Ben from Vic. in forum GENERAL & SMALL MACHINERYReplies: 0Last Post: 10th May 2009, 10:18 AM -
Sliding bench extension for SCMS - Anyone??
By Hardenfast in forum TABLE SAWS & COMBINATIONSReplies: 3Last Post: 9th June 2006, 08:30 AM