Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Help-Which chain to use
-
9th August 2010, 07:56 PM #1New Member
- Join Date
- Aug 2010
- Location
- australia
- Posts
- 3
Help-Which chain to use
have been using 404 skip tooth at 10 degrees for milling slabs with 42 inch bar, have been asked to mill 3x4 and 6x3 out of stringy bark for horse stables, going to use 090 or 084 with 36 inch bar, finish doesnt have to be same quality as for slabbing can i use 30 degree 404 skip tooth. advise would be helpful
-
9th August 2010 07:56 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
9th August 2010, 10:21 PM #2
30 deg skip tooth will cut fater than 10 deg and finish wont go down that mutch.
www.carlweiss.com.au
Mobile Sawmilling & Logging Service
8" & 10" Lucas Mills, bobcat, 4wd tractor, 12 ton dozer, stihl saws.
-
9th August 2010, 11:11 PM #3
Should be ok if finish isn't a concern
I love my Lucas!! ...just ask me!
Allan.
-
10th August 2010, 12:55 AM #4
I think the general concensus is u might get more washboard effect but other than that no probs
Pete
-
11th August 2010, 08:52 PM #5
what ever is on the saw at the time!!!
I am told that sharpening handsaws is a dying art.... this must mean I am an artisan.
Get your handsaws sharpened properly to the highest possible standard, the only way they should be done, BY HAND, BY ME!!! I only accept perfection in any saw I sharpen.
Similar Threads
-
Chain saw Chain Quality
By STAR in forum SMALL TIMBER MILLINGReplies: 40Last Post: 6th March 2012, 07:20 AM -
Chain saw oil
By STAR in forum SMALL TIMBER MILLINGReplies: 34Last Post: 27th June 2009, 12:07 AM -
chain saw
By texx in forum WOODIES JOKESReplies: 4Last Post: 14th February 2009, 09:34 PM -
Chain Saw
By Les in Red Deer in forum SCROLLERS FORUMReplies: 7Last Post: 15th September 2008, 03:47 PM -
box chain
By Ivor in forum BOX MAKINGReplies: 13Last Post: 19th March 2006, 10:58 PM