Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 9 of 9
Thread: White Ants in silky oak slabs
-
15th September 2011, 08:01 AM #1
White Ants in silky oak slabs
Ok, so I got all excited when I bought my Lucas, and got stuck in and slabbed an old silky oak log that had been laying around for about 4-5 years.
Took the resulting slabs back home and as I was stacking them found evidence of white ant activity .
I was hoping that it was old activity , and they had moved out, but alas, fresh evidence of the little buggers in residence.
Can anyone sugest an effective, cost efficient method of terminating the termites without losing the slabs?
So far it would appear that they are mostly down at the butt end of the slabs, I would rather keep as much of the slab intact as possible, but am open to all sugestions....
Thanks in advance for any help
-
15th September 2011 08:01 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
15th September 2011, 04:44 PM #2Skwair2rownd
- Join Date
- Nov 2007
- Location
- Dundowran Beach
- Age
- 76
- Posts
- 19,922
Slab it all, seal the ends. Blast the little mongrels out with a high pressure cleaner or hose, stack where ther is plenty of light ( but not heat ) and turnand turn very frequenlty.
Termitesdfon't like to be disturbd and they don't like light. The treatment I have prescribed should have them buggering off quick smart.
-
15th September 2011, 07:23 PM #3GOLD MEMBER
- Join Date
- Feb 2005
- Location
- Sydney
- Age
- 74
- Posts
- 1,389
silky
They will only eat the sapwood, so don't worry too much
Greg
-
15th September 2011, 08:12 PM #4
They will eat the heartwood of Southern Silky Oak....not much they dont eat
Mapleman
-
15th September 2011, 09:10 PM #5
Try three drops of "Frontline plus" on a small bit of mince, about a third of a cup. Put it in a small (100mm) plant pot upside down and bury it a few inches under the ground. Bury three or four. My neighbour did this 6 months ago, and it has proved successful.
JimSometimes in the daily challenges that life gives us, we miss what is really important...
-
15th September 2011, 11:55 PM #6GOLD MEMBER
- Join Date
- Aug 2011
- Location
- bilpin
- Posts
- 3,559
Wash down slabs with Borax and water solution. This will not only help with termites but also borers like Lyctus who are sure to show up sooner or later. Sticker out the slabs at 450mm centres for less than 50mm thickness and 600mm centres for over. Start stickers close as possible to the ends and keep them in line verticaly. Give your sticker a dose of Borax as well, unless they are treated pine. I only leave cedar untreated and even then have had the stickers eaten out by termites.
-
16th September 2011, 07:15 AM #7GOLD MEMBER
- Join Date
- Oct 2003
- Location
- Sydney,Australia
- Posts
- 3,157
If you've moved them well away from their original location - several blocks not feet - then they are on borrowed time - the queen termite will still be in the old nest underground - the only risk is that the main nest body is in the slabs, so they can just make connecting runways even if the timber is stickered etc. A bit of insect spray will kill loose workers, heat, pressure cleaning etc. are good also & will work well if there is no source of replacement workers.
Treated pine can also give them a terminal gut ache, so use H5 for supports & stickering.
-
16th September 2011, 07:29 AM #8
Thanks every one for the great info, I will try a few ideas and see what works best.
Have agreat weekend
-
16th September 2011, 09:44 AM #9Senior Member
- Join Date
- Jun 2010
- Location
- Canberra
- Posts
- 195
If you can find one of those massive meat ant nests you can lay timber on it for some "natural" termite control. The ants will clean them up pretty quick in a few hours if they can get at them.
Similar Threads
-
Bloody White ants
By Fireguard in forum HAVE YOUR SAYReplies: 7Last Post: 20th February 2010, 12:50 AM -
bugs / white ants??
By GC in forum WOODTURNING - GENERALReplies: 7Last Post: 23rd December 2005, 08:52 PM