Thread: $10 saw stabilization bracket

Got a PM from Revlis asking for more detail on the home made saw stabilization bracket so here are some explanatory photos. The brackets are all from el cheapo plastic handled $2 sliding bevels bent in a vise. I used fixings from the same with some locking washers where needed. The hose clamps are from a cheap MYO kit where you cut your own lengths (about $3). Total cost was about $10 and involved only drilling one extra hole in the chassis.

Photos:
1) Final setup.
2) First bit - screwdriver points at the only bolt I custom drilled a hole in the chassis for.
3) Vertical support attached.
4) Two hose clamps fastenning the bracket and bolt to saw.