Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
-
23rd April 2022, 01:45 PM #1Novice
- Join Date
- Mar 2017
- Location
- West Footscray
- Posts
- 10
Can't lock TSA001 to baseplate on Workcentre 2000
Hello!
My height adjustment lever won't lock my TSA001 flat to the baseplate. It's attached to a Workcentre 2000.The position where it locks securely gives me just enough blade height to cut 19mm pine.
I haven't used it for a while. Am I forgetting something really basic?
Cheers
Michael
-
23rd April 2022 01:45 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
23rd April 2022, 02:32 PM #2
The lever is a spring loaded adjustable type. Set the saw to it's minimum depth of cut and then tighten the lever. Give it a pull as if you were trying to pull it out of the saw body; it comes out about 4mm and becomes free spinning so you can then reset it at a different angle.
TSA001.jpg
The manual for this saw can be found HERE; courtesy of the ACT Triton Owners ClubNothing succeeds like a budgie without a beak.
-
23rd April 2022, 03:25 PM #3Novice
- Join Date
- Mar 2017
- Location
- West Footscray
- Posts
- 10
Thank you so very very much, Chief! I was pulling at the top of the lever. Doh!
Similar Threads
-
N.S.W. Triton Workcentre 2000 Accessories (no workcentre)
By richard_o in forum WOODWORK - Tools & MachineryReplies: 10Last Post: 23rd October 2018, 09:28 AM -
TSA001 and Mk3 workcentre
By rocketwiz in forum TRITON / GMCReplies: 1Last Post: 10th January 2014, 04:39 PM -
Router/Jigsaw Table Series 2000 & Workcentre 2000
By GarethR in forum TRITON / GMCReplies: 2Last Post: 12th May 2013, 01:53 PM -
What saw for a Triton 2000 Workcentre?
By The Duke in forum TRITON / GMCReplies: 23Last Post: 28th October 2005, 12:14 AM -
64 tenons on my 2000 workcentre
By jow104 in forum TRITON / GMCReplies: 6Last Post: 9th July 2004, 05:57 PM