Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
-
1st October 2019, 03:43 AM #1New Member
- Join Date
- Oct 2019
- Location
- Hereford, UK
- Age
- 72
- Posts
- 3
Drill hole in MK3 work centre for router microadjuster
Brand new to all this. Can’t decide if there’s a right or wrong way to mount Triton JOF001 router in the table. And as the microadjuster won’t wind properly to get the collet above the table thought I’d drill a hole to use the tabletop winder handle instead. Before I do (cos there are strange slots...) am I doing the right thing? Can’t see how to add a photo...
-
1st October 2019 03:43 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
3rd October 2019, 07:12 AM #2New Member
- Join Date
- Oct 2019
- Location
- Hereford, UK
- Age
- 72
- Posts
- 3
Too late!
-
3rd October 2019, 10:35 AM #3
-
4th October 2019, 03:20 AM #4New Member
- Join Date
- Oct 2019
- Location
- Hereford, UK
- Age
- 72
- Posts
- 3
Hello!
It means that it was a lightly embarrassing question anyway - obviously I’ll need to drill a hole.
Secondly the microadjuster wont screw all the way down so I couldnt change the router bit anyway - so now its on its way back to the factory to be checked. They say they havent heard of this problem before. I had to take it out of the table then give a real bang down to get it fully down, which is obviously no good.
Thirdly - I suppose the real question was - is there a good way and a bad way to orientate the router in the table so I dont drill the hole and then find out a better place?
For instance I did get it all set up, centred and everything, then found that the exhaust place to attach my dust extractor to couldnt be accessed.
Simple stuff, if I could see a set up it would be obvious (even to me)...
Similar Threads
-
New Work Centre.
By double.d in forum WOODWORK PICSReplies: 0Last Post: 28th November 2016, 11:58 AM -
Need help fitting Triton work Centre 2000 and Triton Router Table 2000 to The Paulk
By barrysumpter in forum TRITON / GMCReplies: 0Last Post: 23rd April 2016, 09:34 AM -
Torque work centre for work space
By carrom in forum WOODWORK - GENERALReplies: 0Last Post: 30th December 2009, 05:29 PM