Thread: GMC Powered Router Table

The best thing you can do with a GMC powered router table is put it in the trailer and take it to the local tip. Seriously, it's not worth the effort.

Originally Posted by Gumby

The best thing you can do with a GMC powered router table is put it in the trailer and take it to the local tip. Seriously, it's not worth the effort.

John, hopefully you've seen enough from other threads and helpful responses to know that that is not typical of what most members enjoy this forum for.

I hope someone is able to help you out with the offending parts, or at least rig something up to do the job

Hi John

Sorry, I can't help you at all but wanted to say that you Men's Shed blokes are awesome. The opportunity and connection you guys provide to men across this country is amazing. I consider myself very fortunate that I have a social network, access to tools and a place to work. I also take comfort in the fact that if I didn't have these things that the Men's Shed community exists.

I hope to contribute to this fine establishment one day when life slows down a little.

Danny

Thanks for your responses. We'll have a go at trying to make up something to do the job, there's a small picture in the instruction book but it does not show any detail but we should be able to figure something out.

cheers

John

Hello JD,

I think we have one of these at the Hills Mens Shed.

I will investigate, but cannot do that 'till next Wednesday.

I'll get back to you soon as I can.

i have that table contact me i can get any details you need photos & sizes
I only have the one adjustment tool so I cant send it but will measure
do you have the spanner I can get details of this also

regards Michael

Thanks for that Michael,

Detailed photos and measurements would be great, we could then make something up to do the job. We do have the spanner. Looking forward to hearing from you.

Regards

John D

john
I have those photos & also a tracing of the tool
if the pictures here are no good send me you email address & i will forward them on
sizes are length 104mm X 50mm
hole in centre is 36mm & 72 with the cut outs to the legs
legs are 11mm long by 8mm wide
material is 2mm thick
regards Michael

Thanks for sketch and photos Michael.

The sketch is too small to read dimensions off and the photos a bit small to print. Are you able to pm me with larger versions of the sketch and photos?

Cheers

John

John, if you click the thumbnails they should open up lager in a new window/tab. Click the new images, and they will supersize. Or right click the new images, and 'saveas' to your pc. Works okay for me.

Thanks Chris, I was just saving the images off the page. All OK when you open up in new tab.

Michael, Thanks very much for all that - we will start trying to make that up tomorrow.

Thanks everyone for your help and advice.

Cheers

John D

John how did you get on with the adjuster
Regards Michael

Hi Michael,
Just back from visiting the grandkids in Queensland. Last I heard, one of the guys at the Shed was going to make something up using the sketch and photos as a guide. I'll find out when I get back to the Shed next week.
Cheers
John

look forward to hearing how it worked out John.