TRA001 Router support table top winder?

**maphew_gq** · 1st March 2012, 01:22 PM

Hi - I have a TRA001 Triton router which I'm waiting for a 1/2" to 1/4" collet on order.
I'm using this with the Router table and stand. Does this router support the table top winder to adjust router tip height?

Thanks

**malb** · 1st March 2012, 07:10 PM

My understanding is that the original TRA did not support a through the table winder. The smaller MOF serties introduced this to the range a couple of years after the TRA was launched.

The current series TRB apparently has been upgraded to incorporate through table winder support.

At about the time of the GMC/Triton crash, when Bunnings were clearing MOF routers for $99, someone on the forums posted that they had incorporated the winder mechanism from a MOF series into a TRA. Link here.

An alternative approch is to use a third party Router Raizer.

Hope this helps.

**bpj1968** · 5th March 2012, 08:20 AM

I don't have a through table winder, i find that as I am crouched down getting at eye level to the cutter that it is easy to reach under and adjust with a few twists, I think reaching up and over may be harder

**Gwhat** · 6th March 2012, 07:52 AM

Hi

We've been selling this for 5 or so years. It works well and is specifically packaged for the TRA001.

Regards

Grahame

Thread: TRA001 Router support table top winder?

Thread Tools

Search Thread

TRA001 Router support table top winder?

Look at the Router Raizer

Similar Threads

TRA001 height winder conversion

Triton TRA001 to MK3 router table

Raising TRA001 router collet in table

Router Table for TRA001

Router table for Triton TRA001

Tags for this Thread

Posting Permissions