Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
-
28th July 2012, 01:45 PM #1New Member
- Join Date
- Jul 2012
- Location
- sydney
- Posts
- 5
Triton MOF001 to old RTA300 plate
Hi all,
I just can't figure it out... How am I going to attach the triton MOF001 router to this router table plate? I landed this older RTA300 table and don't know how these pieces are supposed to attach. I looked in the instructions but couldn't find anything
I've attached some photos to show what I'm talking about.
Thanks.
-
28th July 2012 01:45 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
28th July 2012, 03:48 PM #2
Hi,
Hope this helpsHugh
Enough is enough, more than enough is too much.
-
28th July 2012, 04:54 PM #3
Move the 4 bolts into the slotted holes in the mounting brackets.
Should then fit OK.
Hope this helps.
Keith.
-
28th July 2012, 06:55 PM #4New Member
- Join Date
- Jul 2012
- Location
- sydney
- Posts
- 5
Instructions! Thank you. It is basically as i expected but it looked like the clamps on the plate were supposed to fit somewhere in particular on the router. I just found the best spot and it seems to be holding ok.
My only problem is i have no small insert ring or alignment tool so i have the router centred as much as possible by eye in the hole. A little bit fiddly. i am sure it will be ok if its not dead-centre - but i am obviously not speaking from experience
Very much appreciated. Thanks.
Mark
-
28th July 2012, 07:24 PM #5
The alignment tool isn't needed with the Triton routers as you wind the collet up into the ring as it is the same diameter as the tool, but if you do not have the small insert, you still have a problem.
RegardsHugh
Enough is enough, more than enough is too much.
-
28th July 2012, 08:06 PM #6New Member
- Join Date
- Jul 2012
- Location
- sydney
- Posts
- 5
Ok thats good to know. I'll try to track one down.
Thanks again!
-
6th August 2012, 08:51 AM #7Senior Member
- Join Date
- Apr 2008
- Location
- Perth
- Posts
- 289
Holesaw
Hi
I just used a holesaw to cut out a plug of wood the same dia of the hole in the mounting plate, inserted a cutter into the router, lowered that through the plug, then done up the brackets. Worked when I had my Triton setup.
DD
Similar Threads
-
Triton MOF001 Q's
By benupton in forum TRITON / GMCReplies: 11Last Post: 18th November 2012, 06:14 AM -
Help! Weird RTA300 Mounting Plate
By Bismar in forum TRITON / GMCReplies: 8Last Post: 7th December 2008, 08:22 PM -
Triton MOF001 comes out on top
By lesmeyer in forum TRITON / GMCReplies: 18Last Post: 5th January 2007, 01:30 PM