Thread: Triton Owners Club Oyster Bay (Sydney)

I don't supose anyone will be attending this meeting armed with a video camera will they??
I have just started using the Gifkins jig with a Triton router table/ Bosche router & would also love to get into fingerjointing with either the Triton 2000 table or the router table.
Sounds like this session is just what I'm looking for - but I'm in Melbourne (
Can anyone help?

Cheers,
Greg

Hi Greg,

Roger puts out a video that goes in detail as to the construction of boxes as well as setup of the jig. I think from memory it retails for about $59.00. I think it is quite a lengthy video and if what I have seen in the detail of Roger's plans are anything to gauge it by then I'm sure it would be a worthwhile investment. Failing that the Triton Training video has an interesting section on finger jointing using the saw. I prefer the router to make the cuts myself. Some of the members of the Owners Club here in Sydney have devised various jigs to finger joint. These range from a sled type arrangement with built in dust extraction to a screw thread type where you count equal turns between each cut.

Hope this helps. Let me know if I can help in any other way.

Regards,

Dave

HI Dave,
I'm a member of the Triton Users Group Holmesglen in Victoria. I was curious as to the dovetail jig and executed a quick search on the internet and found this address:

http://www.gifkins.com.au/

Be sure to read the BOTTOM of the template specs page on:
http://www.gifkins.com.au/TemplateSpecifications.html

Thanks,
Barry G. Sumpter
Proud Tritoneer


[This message has been edited by barrysumpter (edited 04 June 2000).]

Thanks Barry,

I am also an owner of the jig and have found it to be extremely simple to use and above all - accurate!!

Regards,

Dave

------------------
Measure twice - cut once!!