Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: WC2000 blade not 90deg
-
2nd July 2020, 12:09 AM #1New Member
- Join Date
- Mar 2018
- Location
- Albany
- Age
- 40
- Posts
- 9
WC2000 blade not 90deg
Hey guys!
I have aquired a few bit of gear over the last couple of years. A Workcentre2000 with C9 saw, extension slide table, router table top with router, original castors. (All up less than $400) All in pretty decent nick
Havent mucked aroubd with it too much but when I did i couldnt get the blade straight up and down vertical. The saw cant adjust that way. It has the older style chassis and I see it looks like it sags a bit.
Is there any ways to remedy this? Ideally I would like to get the new chassis with a height adjuster winder but failing that can i beef up the chassis?
Thanks for your help in advance
-
2nd July 2020 12:09 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
5th July 2020, 07:10 PM #2SENIOR MEMBER
- Join Date
- Feb 2012
- Location
- Rosslyn Park, Adelaide
- Posts
- 182
I used a couple of shims to adjust mine.
I found it rigid enough for my use, so did not do anything else.
Regards
Bauldy
-
6th July 2020, 11:12 PM #3GOLD MEMBER
- Join Date
- Nov 2009
- Location
- Canberra
- Posts
- 1,301
You can get the new chassis and the height winder, but only if you are prepared to sacrifice an arm and a leg, and then you wouldn't be able to operate it!
-
6th July 2020, 11:16 PM #4New Member
- Join Date
- Mar 2018
- Location
- Albany
- Age
- 40
- Posts
- 9
Thanks for the replies guys. I have seen the stabilising bracket, might look into something like that.
I have shimmed mine up but i dont trust it long term. Perhaps i need a better shim.
Those accessories aint cheap!
Similar Threads
-
Line Shaft 90Deg Belt Turn
By DSEL74 in forum METALWORK FORUMReplies: 10Last Post: 26th August 2015, 01:27 PM -
Cutting a 90deg into sheet
By vicente in forum WOODWORK - GENERALReplies: 7Last Post: 21st April 2012, 12:14 PM -
WC2000 blade hitting infill strip.
By Ozkaban in forum TRITON / GMCReplies: 2Last Post: 9th December 2008, 02:52 PM -
.Saw blade guard on WC2000
By pommyphil in forum TRITON / GMCReplies: 10Last Post: 26th October 2008, 04:18 PM -
WC2000 top for Mk3
By scubabob in forum TRITON / GMCReplies: 1Last Post: 18th September 2006, 01:27 AM