Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
-
5th February 2008, 02:48 PM #1
Workcentre & dust ectractor problem
Hi Guys,
Just bought a dust extractor for my wc2000. My problem is that the outlet connection point on the triton saw interferes with the hose connection when I lower the blade. I am looking for a bend to connect to the saw to go under the rail of the wc200 so the flex from the extractor doesnt keep interfering when I lower the blade. Any suggestions would be appreciated.
Cheers,
buballo
-
5th February 2008 02:48 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
5th February 2008, 02:52 PM #2
Hi
My recollection is that the dust extractor hose only goes into the blade guard. For under table collection Triton make the grey felt dust bags or you can make a doohickey to catch it below the table. But it isn't designed to attach directly to the saw except when the saw id being used separately from the Workcentre.Cheers
Jeremy
If it were done when 'tis done, then 'twere well it were done quickly
-
5th February 2008, 04:00 PM #3Intermediate Member
- Join Date
- Jun 2004
- Location
- Bacchus Marsh VIC
- Posts
- 36
I found using plastic elbows meant for electrical conduit or plumbing to be useful. You might have to use a a few wraps of electrical tap to "bulk up" the end of the fitting for a snug joint.
-
6th February 2008, 10:06 PM #4
Thanks guys,
Bit disappointing that the triton wouldnt be compatible to tell the truth. Will need to make up some gadgets to make it adapt.
Thanks for the assistance.
Similar Threads
-
Dust Collector Problem
By DaveD in forum HAND TOOLS - POWEREDReplies: 5Last Post: 1st February 2005, 10:42 PM -
Workcentre Dust Extraction
By stephenmeddings in forum TRITON / GMCReplies: 1Last Post: 22nd November 2004, 11:46 AM -
fine dust problem
By jstevens in forum FINISHINGReplies: 11Last Post: 21st June 2004, 12:21 AM -
2000 workcentre top problem
By jow104 in forum TRITON / GMCReplies: 4Last Post: 6th May 2004, 06:07 PM -
Triton 2000 workcentre guard problem
By damai in forum TRITON / GMCReplies: 2Last Post: 4th December 2001, 03:28 PM