Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Does my plane need tuning?
-
29th December 2019, 10:19 AM #1GOLD MEMBER
- Join Date
- May 2009
- Location
- melb
- Posts
- 1,125
Does my plane need tuning?
Please see attached shavings
IMG_20191227_111445.jpgIMG_20191227_111452.jpg
The shavings are super thin and its leaving a very nice surface, but the shavings are bunching up this and getting stuck - not shooting out like they used to or rolling out into a coil.
Does that mean the chip breaker is too close to the edge? or is it ok?
-
29th December 2019 10:19 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
29th December 2019, 01:18 PM #2GOLD MEMBER
- Join Date
- Nov 2012
- Location
- SE Melb
- Age
- 64
- Posts
- 1,278
Back off the chip breaker slightly and you should be fine.
-
30th December 2019, 01:24 AM #3
Is that board flat, or are you planing a cup? I suspect that the blade has too much camber, and the chip breaker is a smidgeon too close to the edge.
Regards from Prague
DerekVisit www.inthewoodshop.com for tutorials on constructing handtools, handtool reviews, and my trials and tribulations with furniture builds.
Similar Threads
-
Help tuning hand plane
By yoboseyo in forum HAND TOOLS - UNPOWEREDReplies: 7Last Post: 13th December 2019, 10:11 AM -
Tuning a Smoothing Plane
By rbarnold in forum HAND TOOLS - UNPOWEREDReplies: 1Last Post: 17th April 2008, 05:14 PM -
Plane tuning
By ftje in forum HAND TOOLS - UNPOWEREDReplies: 6Last Post: 24th October 2007, 09:48 AM -
Tuning an old wooden plane
By JDarvall in forum HAND TOOLS - UNPOWEREDReplies: 22Last Post: 22nd November 2005, 09:31 AM -
Plane Tuning
By outback in forum HAND TOOLS - UNPOWEREDReplies: 2Last Post: 3rd February 2004, 07:14 PM