Thread: The Second Stanley Plane Blade Order

If I am not too late, please count me in for:

2 * 2 3/8" Blades to suit #6 / #7 (plus cap irons and screws)
2 * 2-1/8" Spokeshave Blades to suit Record 151

Hopefully I have got this right.

thanks
Derek

Derek I have added you to the list.

Tons of space left.

We are up to 30 bench plane blades, out of one sheets of M2 we can get about 120 bench plane blades.

Helmut

I think you may have missed my request on post #23 for two blades for the 151 spokeshave as it is not listed on your spreadsheet.

regards

Hi TS,

I see you have me down for 2 x 2" irons. Kindly cut that back 1 iron (three total).

Originally Posted by Vann

Please put me down for three irons (blades) as follows:

• Two - 2 1/8" Rebate Blade For Stanley/Record Bench Plane;
• One - 2" Blade For Stanley/Record Bench Plane.

No cap irons for me thanks.

Woodwould, do you have dimensions for the 2 1/8" rebate plane irons?

Cheers, Vann.

Originally Posted by Vann

Hi TS, I see you have me down for 2 x 2" irons. Kindly cut that back 1 iron (three total).

Done

Originally Posted by Vann

Woodwould, do you have dimensions for the 2 1/8" rebate plane irons? Cheers, Vann.

If you or anyone has any dimensions for a 2 1/8" rebate plane iron please PM them to Woodwould, to reduce clutter in the thread.

Originally Posted by Basilg

I think you may have missed my request on post #23 for two blades for the 151 spokeshave as it is not listed on your spreadsheet.

Updated

Hi TS... I PM'd an order. It was :

Can you please put me down for 4 bevelled blades, cap irons and screws please.

Sizes:
1 x 1 3/4"
1 x 2"
2 x 2 3/8"

Cheers

Saw Crack - You have been added to the file.

TS is this the rebate blade you are talking about

If so I would like one for my 10 1/2

Originally Posted by rat52

TS is this the rebate blade you are talking about

If so I would like one for my 10 1/2

Yes it is - I will add you to the list.

Do you want a cap iron with that and do you want the blade beveled for you.

Just resurecting (sp?) this in hope of more interest.

I am very keen for a few blades and chip breakers as I have purchased 4/5 old stanley planes in the past 12 months. i will get back later today with which ones I need once I work them out!

mark

Originally Posted by Bitslong

Just resurecting (sp?) this in hope of more interest.

I had a look at the spread sheet, and we are standing at 40 blades, this means we are about 1/3 the way through a sheet, so their is lots of space left.

I hope to get the ball rolling on the second stanley batch sometime around march 2010, once the chisel order has been wrapped up in February.

Helmut

Put me down for:

1. 2 x 2" blade and cap iron
2. 2 x 2 3/8" blade and cap iron
3. 2 x 2" new cap iron
4. 2 x 2 3/8" new cap iron