Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Alternative to dial gauge
-
2nd October 2013, 05:25 PM #1SENIOR MEMBER
- Join Date
- Jul 2009
- Location
- inverloch
- Posts
- 472
Alternative to dial gauge
As I don't have a dial gauge I put together this jig which uses a digital caliper. This has probably been covered somewhere on the forum but I found it an easy way to set up the blade and the fence relative to the mitre slot.
Saw jig 2.jpgSaw jig 1.jpg
-
2nd October 2013 05:25 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
2nd October 2013, 05:46 PM #2Retired
- Join Date
- May 2012
- Location
- Canberra
- Posts
- 1,820
Indeed. Simple ingenuity rules.
Before I had my razzmatazz dial guage, I used a friction fit bit of timber in the mitre, an almost arbitrary length of timber pined and glued at 90 degrees and put a flat headed plaster board screw in the end.
I would mark the blade tooth with a red texta, rotate the screw out until it absolutely touched kissed the front edge with a "ting", do the rotate 180 thing and slide it to the back tooth.....ting ting ting...
Pretty good I thought. Super fast.
Then I bought the deluxe super snazz dial guage with the little ball bearing mounts and its STILL only 1/1000th out....bugger me! Spend $90 and didn't gain a zac in accuracy and I swear it takes longer as I need to fiddle with the dial!
The old stick and screw is now in full reuse, and sits under the saw in a basket even for checking the Incra fences.
Simple is good
Similar Threads
-
Dial Gauge Addiction
By RayG in forum METALWORK FORUMReplies: 182Last Post: 1st December 2012, 11:04 AM -
One more dial gauge couldnt hurt.
By Stustoys in forum METALWORK FORUMReplies: 16Last Post: 31st January 2012, 07:13 AM -
Hercus thread dial gauge?
By neksmerj in forum METALWORK FORUMReplies: 10Last Post: 4th June 2008, 04:56 PM