The Hammer K3 slider ...




Two years ago I completed a new router table and fence in the outfeed of this saw ...




For a while I've been meaning to change the way the fence is adjusted. Here it is running on a track, and the tall knobs clamp it down. But the downside of this system is that there is no micro-adjust.


Today I got around to modifying the router table fence by connecting it to the rip fence ...




The router table fence was built out of 8040 extrusion, and the side supports are 8020 extrusion attached with brackets ...




The side supports are connected to the K3 rip fence track. This makes it a simple matter to loosen and remove until needed ...




The fence is not only linked to the rip fence, but also adjusted by its micro adjuster. Not only that, but there is a Wixey digital gauge, and this both aids in monitoring the amount of adjustment, as well as marking a position and returning to it ...



Regards from Perth

Derek