Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Dado Set Arbour Notch
-
17th July 2019, 04:47 PM #1GOLD MEMBER
- Join Date
- Jun 2005
- Location
- Helensburgh
- Posts
- 7,696
Dado Set Arbour Notch
I have a CMT dado set that has a notch in the arbour of all the blades and chippers like is shown in the video. It seemed to me it was a registration mark but now I am not too sure and my searching has not come up with an answer. I have to drill holes in the set for drive pins that my saw has as per my other thread. Any ideas or knowledge because none of the videos I have watched even refer to it.
CHRIS
-
17th July 2019 04:47 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
17th July 2019, 05:37 PM #2Taking a break
- Join Date
- Aug 2008
- Location
- Melbourne
- Age
- 34
- Posts
- 6,127
I've seen that little notch on many normal blades as well (Leuco put it on everything), I suspect its there for alignment during manufacturing and/or re-sharpening. FWIW, it's always at the 12 o'clock position with the 2 drive pin holes at 3 and 9
Similar Threads
-
moved up one notch
By texx in forum WOODTURNING - PEN TURNINGReplies: 10Last Post: 23rd June 2009, 02:14 AM -
Top Bloomin Notch!
By funkychicken in forum SMALL TIMBER MILLINGReplies: 6Last Post: 4th June 2009, 09:59 PM -
To Dado or not to Dado? Spindle Moulder or Router?
By Dovetail in forum TABLE SAWS & COMBINATIONSReplies: 6Last Post: 13th October 2007, 01:53 AM -
Moved up a notch or two
By orraloon in forum WOODTURNING - GENERALReplies: 2Last Post: 8th July 2007, 02:26 PM