Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Delta saw failing
-
29th October 2009, 10:01 PM #1
Delta saw failing
Does anyone out there own a Delta 36-600 table saw?
I brought one a couple of years ago second hand and had to replace the little timing belt immediately as the teeth has been stripped off it. At the time I put this down to the fact that the previous owner has used it for cutting firewood and thought it had probably had a hard life, as the blade was very blunt and covered in pitch. I have since replaced the belt twice, and have not put a lot of wood through it.
When I switch the saw on, it is up to speed within about half a second. Do all these saws accelerate at this rate, or is there something wrong with the motor on mine in that it does not have a softer start over maybe a couple of seconds. This must put enormous stresses on the belt.
Dallas
-
29th October 2009 10:01 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
Similar Threads
-
Delta
By casperc in forum WOODWORK - GENERALReplies: 13Last Post: 9th June 2009, 10:48 PM -
Eye Sight Failing...Getting Old
By stevew in forum METALWORK FORUMReplies: 7Last Post: 10th December 2006, 09:32 PM -
Got my new Delta saw !
By scooter in forum SCROLLERS FORUMReplies: 15Last Post: 6th November 2004, 10:42 PM -
Delta P-20
By oges in forum SCROLLERS FORUMReplies: 5Last Post: 28th September 2004, 05:44 PM