Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 17 of 17
Thread: Hammer c3 31 maintenance
-
13th May 2023, 10:07 PM #16
Slider re attached today, jointer blades re assembled, saw blades cleaned and performed some test cuts. Gotta love smooth square cuts!
Next challenge is the internal ducting pipe work such a pain to get it over the rectangle mouth. For now I’m just happy to be up and running again. Machines running well so far. Will clean down the cast iron tops tomorrow
Cheers
Nathan
-
13th May 2023 10:07 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
29th June 2023, 10:14 AM #17
Was an interesting experience to troubleshoot the fact the saw was taking 20 seconds to come to a complete stop. Speaking with Felder and digging through some schematic diagrams we found that the braker board was likely faulty. The ceramic fuse seemed fine but the boards are known to fail occasionally and this is a 2016 model so I ordered a new one for $170. Thankfully I was able to install it myself as all of the wires are plugged so I didn’t need to solder anything just a direct swap out
Love the fact all motors now come to a complete stop within 2-3 seconds. Feels brand new! This machines really coming together and is a powerhouse of capability for my size workshop. Can’t get over how smooth the end grain is after a crosscut from this saw!
Similar Threads
-
DC Maintenance time
By Pat in forum DUST EXTRACTIONReplies: 12Last Post: 28th February 2018, 08:51 PM -
Lathe Maintenance
By HappyHammer in forum WOODTURNING - GENERALReplies: 29Last Post: 15th December 2007, 12:13 PM -
Impact Hammer vs Rotary Hammer Drill
By Burnsy in forum HAND TOOLS - POWEREDReplies: 10Last Post: 17th October 2007, 12:22 AM -
Saw maintenance
By TritonJapan in forum TRITON / GMCReplies: 10Last Post: 16th November 2005, 11:12 PM