Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Lifting pedal and wheel required
-
20th September 2010, 11:24 AM #1GOLD MEMBER
- Join Date
- Mar 2008
- Location
- Townsville, Nth Qld
- Posts
- 4,236
Lifting pedal and wheel required
Can anyone please advise where I might be able to get a lifting pedal and wheel as shown in the photo below? I need one to put on my table saw frame.
It would appear to be just bolted through the frame. Would this be correct?regards,
Dengy
-
20th September 2010 11:24 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
20th September 2010, 12:37 PM #2
There are two wheels attached to the other end of the jointer. It may even be part of a mobile base. Just get an adjustable mobile base for the saw. Not too expensive but very handy with something that weighs over 100kg.
Carba-Tec Mobile Base : CARBA-TECThose were the droids I was looking for.
https://autoblastgates.com.au
-
20th September 2010, 01:48 PM #3GOLD MEMBER
- Join Date
- Mar 2008
- Location
- Townsville, Nth Qld
- Posts
- 4,236
Thanks for the comment, NCArcher, but I need the front foot jack assembly to fit on an exsiting frame, which already has the rear wheels. It is just that my existing front wheels will not fully turn in any direction ( the bracket is not long enough) , and this foot jack seems a much better idea, and cheaper than replacing the existing brackets and wheels.
regards,
Dengy
Similar Threads
-
Pedal Car (and Me)
By AUSSIE in forum TOY MAKINGReplies: 10Last Post: 11th June 2009, 05:27 PM -
Plan for pedal car
By Corcorbear in forum DESIGNS & PLANS FOR PROJECTSReplies: 10Last Post: 9th April 2009, 08:24 PM -
pedal car wheels
By horse123 in forum TOY MAKINGReplies: 5Last Post: 22nd December 2008, 10:30 AM -
spinning wheel plans required
By shayrebel in forum DESIGNS & PLANS FOR PROJECTSReplies: 7Last Post: 28th April 2006, 07:03 PM -
Finishing a laminated pedal
By sam63 in forum FINISHINGReplies: 0Last Post: 5th January 2004, 12:53 PM