Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Luna W64 Combination?
-
21st September 2007, 04:54 AM #1New Member
- Join Date
- Sep 2007
- Location
- England
- Posts
- 2
Luna W64 Combination?
Hi there does anybody here own a luna w64 machine as this is what I have and would like to know if the saw table top is level with the jointer table top as mine are at different hieghts and when useing the fence fitted to the front of the jointer for wider cuts it is a bit of a problem as the work piece tends to lift from the table where the blade is leaving a cut that is not 100% square to the face.
Thanks M4RKE
-
21st September 2007 04:54 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
21st September 2007, 10:36 AM #2
Hey M4RKE,
Need photos!
Never seen a Luna combination!
I have a SCM Combination that has 1 motor running the saw and jointer, so sawing anything over the jointer blades is not on, OK I may have done this a couple of times!
The saw table is 3mm higher than the jointer tables so a 3mm thick aluminium guard was made to cover them, this also acts as a rail to hook the fence over the front edge keeping it square and solid.
Hope this helps. Still need a photo of the Luna though!
-
21st September 2007, 05:12 PM #3New Member
- Join Date
- Sep 2007
- Location
- England
- Posts
- 2
Thanks for your reply Stringy I will get a picture up over the weekend. My machine is a Sweedish made affair that is quite well made Im just not sure about these table hieghts.
Similar Threads
-
Luna W59
By MOM in forum HAND TOOLS - POWEREDReplies: 11Last Post: 1st September 2007, 10:37 AM -
Luna Sawbench
By TSHSR in forum HAND TOOLS - POWEREDReplies: 2Last Post: 31st January 2005, 03:38 AM -
Reviewing the Lie-Nielsen blade/chipbreaker combination
By derekcohen in forum HAND TOOLS - UNPOWEREDReplies: 0Last Post: 14th July 2003, 07:54 PM