Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Rexon RXQ-12 Contractors Saw
-
20th April 2015, 02:11 AM #1Senior Member
- Join Date
- Feb 2014
- Location
- Bne
- Posts
- 383
Rexon RXQ-12 Contractors Saw
Hi Guys, about a month ago I purchased a second hand Rexon 12" table saw, otherwise known as a contractors saw. It is about 20 years old and made in Taiwan. I have a couple of questions, first of all the arbor size and the ability for this saw to run a set of dado blades.
Is there anyone who was the same saw or knowledge of that saw.. could point me in the right direction.
Cheers.
Here is a link to the identical saw, however mine was the factory supplied base.
Thanks in advance.
http://www.gumtree.com.au/s-ad/tweed...saw/1075872262
Tony
-
20th April 2015 02:11 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
20th April 2015, 11:06 AM #2
Are you asking about arbor diameter as well as length?
Here is a link to one that someone else was looking at a while ago which answers the diameter question. https://www.woodworkforums.com/f153/buy-hand-rexon-rxw-12-a-181297
-
20th April 2015, 03:25 PM #3
I have no experience of Rexon saws but to use a dado you need a 5/8'' arbor with enough length to fit the stack on and place the lock nut with holding washers. On my saw with a normal blade I have 16mm of thread to spare outside the lock nut. If you have that then it can take a dado.
Regards
John
Similar Threads
-
Rexon lathe
By Baldone in forum WOODWORK - GENERALReplies: 6Last Post: 6th April 2016, 11:12 PM -
Should I buy a second hand Rexon RXW 12
By TheSchmuck in forum TABLE SAWS & COMBINATIONSReplies: 2Last Post: 30th January 2014, 03:11 PM -
Rexon Saw
By MRNey in forum TABLE SAWS & COMBINATIONSReplies: 3Last Post: 30th April 2012, 01:22 PM -
Rexon web site
By Robo1 in forum GENERAL & SMALL MACHINERYReplies: 1Last Post: 26th January 2008, 08:56 AM -
Rexon tools
By rtfarty in forum HAND TOOLS - POWEREDReplies: 1Last Post: 12th July 2006, 10:48 PM