Thread: Scheppach TS 2500 bench saw

Dear Jock,

I don't think there is any link to one "out there" in cyberspace, but if you send a very nice e-mail to the very nice lady at this address: [email protected]
she will send you one, because they definitely have one there.
I had it, but I lost it when my Hard-Drive bit the dust earlier this year (my fault...)

Make sure you tell her that it's the Extruded-Aluminium version, and make sure that you also ask her to send you the Exploded Parts Diagram and Parts List for the unit. Best Instruction Manual and Parts Diagram I think I've ever seen...

Best Wishes,
Batpig.

Thanks Batpig
I'll flick you on a copy if I get one .

Jock

Originally Posted by Batpig

Dear Jock,

I don't think there is any link to one "out there" in cyberspace, but if you send a very nice e-mail to the very nice lady at this address: [email protected]
she will send you one, because they definitely have one there.
I had it, but I lost it when my Hard-Drive bit the dust earlier this year (my fault...)

Make sure you tell her that it's the Extruded-Aluminium version, and make sure that you also ask her to send you the Exploded Parts Diagram and Parts List for the unit. Best Instruction Manual and Parts Diagram I think I've ever seen...

Best Wishes,
Batpig.

Batpig ,
the PDFs have arrived . Do you want a copy ?

Unfortunatly the one that has an English section is for the cast iron top not the alloy , and they do not have anything about the sliding table and the extension .
There is nothing about fine tuning or trouple shooting .

Jock

Dear Jock,

That's a pity . I'll have a rummage through the drawer where I keep Instruction Manuals to see if I printed out a Hard Copy from the PDF while I still had it, because I'm pretty sure that the edition of the Manual that I received from them was for the "Ally" version of the saw. From memory, there was a small Troubleshooting section, but it wasn't terribly extensive...

Best Wishes,
Batpig.