Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: DeWalt DW125 Powershop RAS - Fix
-
25th August 2015, 02:14 PM #1New Member
- Join Date
- Jul 2009
- Location
- SEQ
- Posts
- 9
DeWalt DW125 Powershop RAS - Fix
This is a great saw, accurate, effortless and very quiet when running. It doesn't get a lot of use though, maybe an hour or two a year since I’ve owned it. It was one of these rare cuts where I pulled the cover sheet of to use it that I had a minor ' oops '.
The table was clean and clear, let’s turn it on. ( Insert oops here ) I was expecting the crisp quiet high speed whirr but instead got a monastic hummmm. I quickly switched it off to investigate.
The saw had been lowered to the extent the blade was touching the bench. I hadn’t noticed this before flicking the switch. Power had been running but the blade couldn't turn.
I then raised the blade, crossed fingers and flicked the switch. The blade started to turn, but nowhere near the normal speed, not even enough to consider a test cut. 2 seconds later, Click, the on board reset switch must have stopped play. Turn off/ on at wall, try again, same result. Remove blade and assembly to bolt blade in place, try again. It spins at let’s say 10% normal speed without setting of the reset button. Put blade back on, slow spin, click, reset turn’s it off.
Asking here is my first step to fixing it. Any suggestions ?
-
25th August 2015 02:14 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
Dewalt RAS DW125 instruction guide
By Misty2055 in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 9Last Post: 21st October 2017, 07:56 PM -
Black and Decker/Dewalt Radial arm powershop
By Makka in forum GENERAL & SMALL MACHINERYReplies: 6Last Post: 10th July 2014, 07:29 PM -
Seeking Manual for DeWalt Powershop dw 125
By LeoWantsManual in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 11Last Post: 9th March 2014, 01:52 PM -
DeWalt DW125 Powershop
By ernstvg in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 4Last Post: 26th June 2012, 01:43 AM