Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
-
25th April 2014, 03:57 PM #1GOLD MEMBER
- Join Date
- Mar 2008
- Location
- Townsville, Nth Qld
- Posts
- 4,236
Flatten wide boards on narrow jointer?
Hello, I have made a mistake while making a chest of drawers, and made three drawers 4mm too wide for the carcase. There are no screws or nails in the glued drawer joints, so I thought the easiest way would be to run two sides of each assembled drawer along my jointer. The sides of the drawers are 18mm thick pine 185mm wide, but I only have a 6" jointer.
Can anyone please advise if it is possible to do this on a narrow jointer?regards,
Dengy
-
25th April 2014 03:57 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
26th April 2014, 06:13 AM #2
You could run it over the jointer leaving a rebate (have to do it in one pass) 35mm wide. Then either handplane the 35mm high part away or use a straight router bit with pattern following bearing to remove it. If you have a table saw you might be able to thickness the side down with the blade at full height and rotate 180 to complete, then tidy up with plane or sander.
-
26th April 2014, 07:35 AM #3GOLD MEMBER
- Join Date
- Mar 2008
- Location
- Townsville, Nth Qld
- Posts
- 4,236
Thanks Doc, will do the rebate and lower the high part with a hand plane.
Many thanks for the warning of doing it in one pass!! I was intending to do it gradually in 1mm passes.regards,
Dengy
-
26th April 2014, 11:37 AM #4
Jig
You can do multiple passes if you want to make up a simple jig for the indeed table. 4mm thick MDF or ply 150mm wide and a bit longer than the length of the infeed table. Put a block under one end to stop it sliding forward and you can now run the rebated side at whatever thickness you want until the rebate is 4mm deep.
-
28th April 2014, 01:32 PM #5GOLD MEMBER
- Join Date
- Mar 2008
- Location
- Townsville, Nth Qld
- Posts
- 4,236
Excellent result
Thanks Doc, found some nice smooth faced 3mm melamine, cut it to the profile of the infeed, clamped it to the infeed table, then planed each drawer side 2mm using the jointer, in 0.5mm passes. Turned out perfectly.
Many thanks for your helpregards,
Dengy
Similar Threads
-
Do you flatten your vintage jointer plane?
By snafuspyramid in forum HAND TOOLS - UNPOWEREDReplies: 2Last Post: 10th March 2013, 01:14 PM -
wide boards
By DThew in forum TIMBERReplies: 1Last Post: 27th January 2013, 05:39 PM -
Wide boards in SA
By Rounsie in forum TIMBERReplies: 5Last Post: 21st September 2010, 05:18 PM -
Circular saw jig to cut narrow boards
By ORYX in forum HAND TOOLS - POWEREDReplies: 7Last Post: 2nd June 2010, 08:56 PM -
Jigs for thicknessing narrow boards
By mat in forum HAND TOOLS - POWEREDReplies: 3Last Post: 21st July 2006, 04:21 PM