Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
-
15th December 2012, 03:05 PM #1
Help Needed, Adjustment of PT IN/OUTfeed Tables (Scheppach HMS 2600ci)
Need some assistance setting the in- and outfeed tables on my 2600. The manual is rubbish and I cannot find any instructions on how to do this. Does anyone who owns this machine or similar have some detailed instructions on the best method of adjusting the tables so they are coplanar and the cutting block is cutting evenly?
I've attempted to align the tables by adjusting the resting blocks on either side of the outfeed table while using a straight edge and the infeed table as a reference. I've not had much luck so any assistance would be greatly appreciated.
In general is the above methodology about the right way to go about adjusting PT tables?
Thanks,
GarethAnnular Grooved Nails....Ribbed for the Woods Pleasure?
-
15th December 2012 03:05 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
16th December 2012, 09:44 AM #2
Outfeed Table Wobbles
After working on my problem this morning I discovered that the outfeed table wobbles slightly, such that when I pass wood over the infeed table onto the outfeed table and start using that as the reference surface the outfeed table would drop slightly. I've tightened everything up and the offending piece appears to be the hinge onto which the outfeed table is attached.
Not overly optimistic about solving my issue. Was hoping to get some planing done on my new machine this weekend but that's looking highly unlikely.Annular Grooved Nails....Ribbed for the Woods Pleasure?
Similar Threads
-
Jointer adjustment help needed
By Scally in forum HAND TOOLS - POWEREDReplies: 3Last Post: 29th May 2007, 01:35 AM -
Outfeed stand
By Andy Mac in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 14Last Post: 31st March 2006, 10:02 PM -
Roller infeed/outfeed table
By Sturdee in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 9Last Post: 15th October 2003, 09:44 PM -
Outfeed tables for the MK3
By Sturdee in forum TRITON / GMCReplies: 11Last Post: 6th October 2003, 11:24 PM -
planer attach - outfeed finger
By GeoffS in forum TRITON / GMCReplies: 3Last Post: 21st May 2003, 04:06 AM