Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: help with a spindle moulder
-
5th November 2012, 07:12 PM #1Novice
- Join Date
- May 2009
- Location
- Thames NZ
- Posts
- 12
help with a spindle moulder
Hi All
yesterday I needed to run a 3300mm board through the spindle moulder, Unfortunatly the wall is 2500mm away so I dragged the spindle moulder back a metre and managed to hook the cable and pull the wires from the motor out of the little holes they go into. The earth stayed in its hole but the phase and nutral came out and i dont know what little holes to put them back into (not well labled) My partner got in touch with the manufacturer to see if I could get a wiring diagram (i was busy working) but the tech support didnt appear very helpful and there was no wiring diagram that they could send me. I will give them a ring in the morning and see what I can get from them, but thought I would ask here in case any one can help.
The spindle moulder is a Tooline MX5108.
All I need is to know where the phase and nutral (the red and black wires) from the motor goes...A photo of the wiring or a wiring diagram would be great if possible
Cheers
Rodney
-
5th November 2012 07:12 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
5th November 2012, 08:35 PM #2
Maate
I would call on an electrician. May be dollars involved but what is peace of mind worth?Just do it!
Kind regards Rod
Similar Threads
-
Spindle moulder help????
By TTIT in forum WOODWORK - GENERALReplies: 16Last Post: 21st April 2009, 03:50 AM -
Spindle moulder or Planer/moulder
By HaydnG in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 8Last Post: 19th May 2006, 11:23 PM -
spindle moulder
By sinjin1111 in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 0Last Post: 17th May 2005, 04:18 PM -
Spindle Moulder
By canonbal in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 5Last Post: 18th May 2004, 09:45 AM