Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
-
6th February 2014, 10:35 PM #1SENIOR MEMBER
- Join Date
- Apr 2007
- Location
- Perth
- Age
- 50
- Posts
- 728
Major Dilemma - Carbatec Deluxe Jointer CT-196
Hi Guys
Major Problem - just when I needed it most, need the Wife's pressie finished by Monday and now, I dunno
Firstly I have only had the jointer for under 5 years
Secondly - when I first bought it - motor died first time I used it
I was using it today and going by the manual, tried to adjust the height on the out-feed table.
Whether I rotate the handle clockwise or anti-clockwise (I see the thread moving - and it comes all the way our or goes all the way in) the top will not move. I am guessing that perhaps the top part of the thread is not engaging properly?
Anyone have any ideas?
Then, I went to adjust the height of the infeed table and bang, the handle snapped off at the nut. gggrrrrrrrrr
Now I cannot adjust the infeed or outfeed height.
Question: - just to get me by for this project are there any ways I can temporarily fix this does anyone know.
Much appreciated.
-
6th February 2014 10:35 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
7th February 2014, 09:37 PM #2GOLD MEMBER
- Join Date
- Sep 2010
- Location
- Lebrina
- Posts
- 1,099
Post a couple of photos of the relevant mechanisms if you can.
Similar Threads
-
JET 6" deluxe long bed jointer.
By Robo1 in forum GENERAL & SMALL MACHINERYReplies: 10Last Post: 22nd December 2007, 07:55 PM -
jointer - carbatec 6" deluxe
By dazzler in forum HAND TOOLS - POWEREDReplies: 6Last Post: 29th October 2005, 10:21 PM