Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Square head cutter setup
-
24th July 2021, 10:44 AM #1New Member
- Join Date
- Jul 2021
- Location
- Lidster
- Age
- 51
- Posts
- 2
Square head cutter setup
I have a Jeffwood 703, everything run well.
I need to have the irons sharpened, which is no issue.
Does anyone here have the knowledge or can point me to it, to correct set the blades when reinstalling?
It appears to be a bit more specialised than doing blades on a round head cutter.
Many thanks.
-
24th July 2021 10:44 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
27th August 2021, 01:16 PM #2
You might try a PM to Melbourne Matty - L.S.Barker1970 on this forum. He runs some square head machines.
Cheers, Vann.Gatherer of rustyplanestools...
Proud member of the Wadkin Blockhead Club .
-
27th August 2021, 03:06 PM #3GOLD MEMBER
- Join Date
- Jul 2011
- Location
- In between houses
- Posts
- 1,784
We used to just measure off the face of the head to the edge with a 6” engineers rule. Then just roll the head around and use a block of hardwood on each side of the table, adjust the table up so one side just brushes the block, then check the other side. they’re pretty easy actually, then just do the bolts up, real tight.
Similar Threads
-
VICTORIA Dewalt DW735 Planer with spiral head and Jet 6inch jointer with bryd Cutter head
By hhpcheah in forum WOODWORK - Tools & MachineryReplies: 7Last Post: 11th January 2020, 10:23 PM -
Square Head Nails
By Chris Parks in forum RESTORATIONReplies: 28Last Post: 25th March 2018, 03:41 PM -
The Square Head Thread.
By L.S.Barker1970 in forum ANTIQUE AND VINTAGE MACHINERYReplies: 49Last Post: 12th October 2015, 01:57 AM -
Table saw post setup head scratcher.
By markwearspants in forum TABLE SAWS & COMBINATIONSReplies: 6Last Post: 27th May 2014, 11:54 AM -
Where to get big square-head bolts?
By Gunnaduit in forum WOODWORK - GENERALReplies: 16Last Post: 21st August 2009, 08:53 PM